Wire-Wrapping Tutorial: Simple Wire Brooch

In this wire-wrapping tutorial, I’ll show you how to wire-wrap a simple wire brooch, perfect for sweaters and scarves!

This wire-wrapping tutorial is a great introduction to wire-wrapping with thicker wire – it’s suitable for all beginners and you can use any gemstone bead you have on hand.

Prefer this tutorial in a PRINTABLE FORMAT?

Click here for the PDF version of “How to Wire-Wrap a Simple Wire Brooch”

Wire Wrapping Tutorial Simple Wire Brooch

LEVEL: BEGINNER

MATERIALS + TOOLS

15” – 12 gauge wire of your choice (dead soft)
6” – 24 gauge wire of your choice (dead soft)
10-12mm gemstone bead of your choice
Round nose pliers
Needle nose pliers
Wire cutters
Heavy duty cutters
Anvil or bench block
Hammer
File
Wire gauge tool (not required but nice to have)
Liver of sulfur (if you choose to patina)

HOW TO WIRE-WRAP A SIMPLE BROOCH

STEP 1

Start about 4” from the end of the wire. (fig. 1a). Place round-nose pliers at the 4” mark (fig. 1b) and start bringing wire around and over the short wire. (fig. 1c, 1d, 1e).

FREE WIRE-WRAPPING GUIDE TO YOUR EMAIL!

JOIN NEWSLETTER

We respect your privacy. Unsubscribe at anytime.

Prefer this tutorial in a PRINTABLE FORMAT?

Click here for the PDF version of “How to Wire-Wrap a Simple Wire Brooch”

STEP 2

Keep bringing wire around to form a loop for the bead to sit on. (fig. 2a, 2b, 2c, 2d) This first loop should be SMALLER that the circumference of the bead. As you can see, my bead is falling through this loop because it’s too big. (fig. 2e)

RELATED CONTENT

Step 3

If your loop is too big for your bead, keep tightening it to make it smaller (fig. 3a, 3b, 3c). Now if I place my bead on the loop, it does not fall through (fig. 3d). Make sure you leave a small gap in the loop as shown in this sideways view (fig. 3e). You’ll need some room to feed your wire through to secure bead (shown in next step).