Step 6 of 13
For this step, we will be weaving the main frame and secondary frame together in place.
Firstly, have the back side of main frame face you and start a new string of 24-gauge wire (fig. 6a).
Anchor the 24-gauge wire on the top left side of the main frame for two loops (fig. 6b, 6c).
FREE WIRE-WRAPPING GUIDE TO YOUR EMAIL!
JOIN NEWSLETTER
We respect your privacy. Unsubscribe at anytime.
On the pendant front side, weave the main frame and the secondary frame on the bottom side of both frames for 4 loops (fig. 6d, 6e, 6f, 6g, 6h, 6i, 6j, 6k).
Lastly, cross the remaining wire and anchor the last point on the top left side of the main frame (fig. 6l, 6m, 6n).
Trim the excess 24-gauge wire (fig. 6o).
The back side of your pendant should look like (fig. 6p).
Step 7 of 13
After that, we continue to add details to the frames.
On the front side of your pendant, start a new string of 24-gauge wire at the bottom right side (fig. 7a).
Weave the whole frame bundles for four loops as shown (fig. 7b, 7c, 7e, 7d, 7f, 7g, 7h).
Trim off the lower part of the excess wire (fig. 7i).
Step 8 of 13
We proceed to give a dimensional look by weaving through the wire frame bundles.
Begin with wrapping only the last two wire frames as shown (fig. 8a, 8b).
Then, pull the 24-gauge wire to the front-most wire frame (fig. 8c, 8d, 8e, 8f) and anchor it for two loops (fig. 8g, 8h, 8i, 8j).
Trim off the excess 24-gauge wire (fig. 8k).
